Product Reviews

Review: I bought my Suzuki Intruder VL 1500 new in 2001. I added a Stage 3 jet kit & Cobra 2" Drag Pipes. Bike ran good for the first 10-12 years. It has sat for two years due to the carb popping/backfiring. I've removed & cleaned the carb and still had the "popping" issue. I finally caved & ordered the GMan Rejet service. Got it back last Friday, installed the carb yesterday & WOW, WHAT A DIFFERENCE!!!! My bike has never ran this good!!! I wish I would of done this years ago!!! The only adjustment I had to make was the idle speed was high. Extremely happy with this purchase!!!

Review: Was low on power and only getting 28mpg. I did the stage 3 with this Needle Jet Service and got tons of power and 39mpg on my first tank. This was awesome!

Review: Great service, worth every penny. I have sent to GMan already 3 sets of carbs from Europe. Satisfaction guaranteed.

Review: Popped carbs back on this am, Stiil three foot snow banks and a sunny three degrees so time to test the rebuild. If you haven't had your carbs done by GMan just do it. Don't hesitate. I hadn't gone a mile and knew it was a smart decision. $ well spent. Best company I have ever dealt with. Got answers over phone and emails immediately. Very quick service!

Review: Had a set of carbs that had been previously worked on, before I owned my bike, that was a horrible job. Sent them in to GMan and got them back a little over a week. Was doing a few other upgrades to bike while doing carb rebuild. WOW at how much different it is. Better throttle response, the GPops for my exhaust, and I couldn't be happier. Did a Stage 3 kit and cut the top out of my K&N Air Filter and man will it get up and go now. Gonna wait about 4-5 tanks of gas through it to really look at mileage and see how much improvement there is. Thanks a lot GMan!!!

Review: Wish I would have done this years ago. Went from 23 to 38 mpg in the first 100 miles after install. No more rough idle and fouled plugs! Smooooth at all rpms. 7 day turnaround thru USPS and instructions clear and easy to follow. Glad I also did the air and fuel filter at the same time. Think I'll keep her now! Thanks GMan!

Review: O MY I just ran 100 miles went from 29 per gallon before GMan to after GMan at 37 per gallon. Bike has never ran this good plus put the auxiliary tank on mine now looking at 222 miles on 6 gallons GMan is the best and only for your VL1500.

Review: What a difference,bike was backfiring running rich and poor mileage, just was not running good, GMAN is AMAZING, bike runs like a bike should. If anybody has the same trouble do not hesitate its well worth saving your bike. Thanks Gary Shipping and handling very fast 12 days it returned to me in Digby Co.,Nova Scotia ,Canada

Review: My Intruder was down to 21 MPG and some lost power. I called and talked to GMan and felt great after talking to him. I sent them off, it was only a week turn around. I also did stage 3 upgrade and WOW. First tank went to 31 2nd tank 35 and the power is awesome. It is like a new bike. I bet I could get better MPG but how do I stay off the throttle. I was close to buying a new bike for 15000.00 I got a new bike for less than 400.00, my old bike I love is my newbie again.. If you have any questions GMan is there to help you in the process. Thanks GMan!!!!!

Review: I sent my carbs in for a Stage 3 since I already had 3" HardKrome Big Straights for pipes. The instructions were very easy to follow for removal and installation, and my bike fired right up on the initial crank after installation. Gary was great to help with a few questions, and I can't say enough about the performance boost. I'm also using significantly less throttle than before while riding. I'd read others say, "you can hear the engine sucking air" and they were right. Highly recommended! I even made a YouTube video to document the results: https://youtu.be/cGhKYIGQhow

Review: I sent my carbs to GMan and it was the best thing I've done with them. The bike runs better and I'm getting better MPG's.

Review: I was the victim of a poorly done rejetting...a previous owner used stainless needles and my needle jets got worn .28 mpg and I sent them in. The rebuild was awesome and I now get the best gas mileage I ever had in the bike. This will pay for itself in no time and well worth the money.

Review: Send my Carbs to GMan from Holland, great service !! Got them back and did a test drive.. 48 Mpg (1:17) instead of the 31 Mpg (1:11). So it will pay it self back, and whatever question you have, Gary will answer them all and will find a solution for every problem. Thanks Gary! Another Happy Customer.

Review: This service is great! Was having troubles with my bike spitting and sputtering and after I got my carbs back. The problem is gone and the power has increased a great deal. Highly recommend this to anybody.

Review: After my Original carb replaced by a secondhand carb from the same year. I got the same problem 1 1/2 year later. Worn emulsion tubes again. Found the GMan website when browsing the net about re-building needle jets, I'm in Holland. After gathering some information from several people I gave it a try and sent my carbs on a journey to GMan Industries. GMan performed very well in rebuilding the carbs. Had my first test ride last weekend and it is amazing. Performance before: 1 liter of fuel for 12 Km after: 1 liter of fuel for 16 km. And when de-accelerating it keeps running smooth no downshifting to keep it smooth running is necessary. I'm very, very satisfied with the work GMan did on my carbs. I will recommend his work to other bikers in Holland and for sure there will be a couple of carbs coming to Renton very soon. GMan keep up the good work, you make a lot of bikers happy. Greetings from Holland, Albert-Jan